(30 days)
A patient examination gloves is a disposabledevice intended for medical purpose that is worn on the examiner's hand or finger to prevent contamination between patient and examiner.
Powder Free Vinyl Synthetic Examination Gloves, White color(Sensi-Pro)
This document is a 510(k) clearance letter from the FDA for "Sensi-Pro Disposable Powder Free Vinyl Synthetic Examination Gloves". It confirms that the device is substantially equivalent to legally marketed predicate devices.
However, the provided text does not contain any information regarding acceptance criteria or a study proving the device meets those criteria, as typically understood for AI/software-as-a-medical-device (SaMD) products.
The information requested in your prompt (acceptance criteria, device performance, sample size, ground truth, expert qualifications, adjudication, MRMC studies, standalone performance, training set details) is highly specific to the evaluation of AI/SaMD devices, which are assessed for their diagnostic or predictive accuracy.
This document is for a physical medical device (examination gloves), which are evaluated based on physical and mechanical properties, barrier integrity, and biocompatibility, not AI performance metrics. Therefore, the requested information is not relevant to this type of device and is not present in the provided text.
To answer your prompt directly based on the provided text, I must state:
- A table of acceptance criteria and the reported device performance: Not applicable. The document is for examination gloves, not an AI/SaMD. Criteria would relate to physical properties, not diagnostic accuracy.
- Sample size used for the test set and the data provenance: Not applicable. No test set for AI performance is mentioned.
- Number of experts used to establish the ground truth for the test set and the qualifications of those experts: Not applicable. No ground truth establishment for AI performance is mentioned.
- Adjudication method for the test set: Not applicable. No test set for AI performance is mentioned.
- If a multi-reader multi-case (MRMC) comparative effectiveness study was done, If so, what was the effect size of how much human readers improve with AI vs without AI assistance: Not applicable. This document pertains to physical examination gloves, not an AI system that assists human readers.
- If a standalone (i.e., algorithm only without human-in-the-loop performance) was done: Not applicable. This document pertains to physical examination gloves, not an AI algorithm.
- The type of ground truth used (expert consensus, pathology, outcomes data, etc): Not applicable. No ground truth for AI performance is mentioned.
- The sample size for the training set: Not applicable. This is not an AI/ML device, so there is no training set.
- How the ground truth for the training set was established: Not applicable. This is not an AI/ML device.
In summary, the provided FDA 510(k) letter is for a medical device (gloves) that does not involve artificial intelligence or software-as-a-medical-device. Consequently, none of the specific details requested about AI/SaMD performance evaluation are present or applicable.
{0}------------------------------------------------
Public Health Service
DEPARTMENT OF HEALTH & HUMAN SERVICES.USA
Food and Drug Administration 9200 Corporate Boulevard Rockville MD 20850
OCT 27 1999
Mr. Huan-Chunq Li Vice President Shinemound Enterprise Inc. 17A Sterling Road North Billerica, Massachusetts 01862
Re : K993240
Trade Name: Sensi-Pro Disposable Powder Free Vinyl Synthetic Examination Gloves Regulatory Class: I Product Code: LYZ September 23, 1999 Dated: Received: September 27, 1999
Dear Mr. Li:
We have reviewed your Section 510(k) notification of intent to market the device referenced above and we have determined the device is substantially equivalent (for the indications for use stated in the enclosure) to devices marketed in interstate commerce prior to May 28, 1976, the enactment date of the Medical Device Amendments, or to devices that have been reclassified in accordance with the provisions of the Federal Food, Drug, and Cosmetic Act (Act). You may, therefore, market the device, subject to the qeneral controls provisions The general controls provisions of the Act of the Act. include requirements for annual registration, listing of devices, good manufacturing practice, labeling, and prohibitions against misbranding and adulteration.
If your device is classified (see above) into either class II (Special Controls) or class III (Premarket Approval), it may be subject to such additional controls. Existing major regulations affecting your device can be found in the Code of Federal Regulations, Title 21, Parts 800 to 895. A substantially equivalent determination assumes compliance with the Good Manufacturing Practice for Medical Devices: General (GMP) requlation (21 CFR Part 820) and that, through periodic GMP inspections, the Food and Drug Administration (FDA) will verify such assumptions. Failure to comply with the GMP regulation may result in requlatory action. In addition, FDA may publish further announcements concerning your device in the Federal Register. Please note: this response to your premarket notification submission does not affect any
{1}------------------------------------------------
Page 2 - Mr. Li
obligation you might have under sections 531 through 542 of the Act for devices under the Electronic Product Radiation Control provisions, or other Federal laws or regulations.
This letter will allow you to begin marketing your device as described in your 510 (k) premarket notification. The FDA finding of substantial equivalence of your device to a legally marketed predicate device results in a classification for your device and thus, permits your device to proceed to the market.
If you desire specific advice for your device on our labeling regulation (21 CFR Part 801 and additionally 809.10 for in vitro diagnostic devices), please contact the Office of Compliance at (301) 594-4692. Additionally, for questions on the promotion and advertising of your device, please contact the Office of Compliance at (301) 594-4639. Also, please note the regulation entitled, "Misbranding by reference to premarket notification" (21 CFR 807.97). Other general information on your responsibilities under the Act may be obtained from the Division of Small Manufacturers Assistance at its toll-free number (800) 638-2041 or (301) 443-6597 or at its internet address "http://www.fda.gov/cdrh/dsmamain.html".
Sincerely yours,
Clalactista
Timothy A. Ulatowski Director Division of Dental, Infection Control and General Hospital Devices Office of Device Evaluation Center for Devices and Radiological Health
Enclosure
{2}------------------------------------------------
Attachment I
INDICATION FOR USE
Huan-Chung Li, Shinemound Enterprise, Inc. Chung Applicant: * K99 3240 510K Number(if known): Device Name: Powder Free Vinyl Synthetic Examination Gloves, White color(Sensi-Pro) Indication For Use:
A patient examination gloves is a disposabledevice intended for medical purpose that is worn on the examiner's hand or finger to prevent contamination between patient and examiner.
(PLEASE DO NOT WRITE BELOW THIS LINE-CONTINUE ON ANOTHER PAGE IF NEEDED)
Concurrence of CDRH, Office of Device Evaluation(ODE)
Prescription Use Per 21 CFR 801.109 (Optional Format 1-2-96) OR
Over-The-Counter Use X
- For a new submission, do NOT fill in the 510(K) number blank
(Division Sign-Off) Division of Dental, Infection Control, and General Hospital De 510(k) Number_
§ 880.6250 Non-powdered patient examination glove.
(a)
Identification. A non-powdered patient examination glove is a disposable device intended for medical purposes that is worn on the examiner's hand or finger to prevent contamination between patient and examiner. A non-powdered patient examination glove does not incorporate powder for purposes other than manufacturing. The final finished glove includes only residual powder from manufacturing.(b)
Classification. Class I (general controls). The device, when it is a finger cot, is exempt from the premarket notification procedures in subpart E of part 807 of this chapter subject to the limitations in § 880.9.