(71 days)
The Atrium Flixene Graft is intended for use in arterial vascular reconstruction, segmental bypass, and for arteriovenous vascular access. Insufficient data is available at this time to support Atrium Flixene Graft use in aortocoronary bypass applications or for use as a patch.
Not Found
The provided text is a 510(k) clearance letter from the FDA for a vascular graft device. It states the review of the premarket notification and the determination of substantial equivalence to legally marketed predicate devices.
However, the document does not contain any information about acceptance criteria or the study that proves the device meets such criteria. It is a regulatory clearance document, not a scientific study report or a summary of performance data.
Therefore, I cannot provide the requested information. The sections you asked for, such as sample size, data provenance, expert qualifications, adjudication methods, MRMC studies, standalone performance, ground truth details, and training set information, are not present in this regulatory letter.
{0}------------------------------------------------
Public Health Service
Food and Drug Administration 9200 Corporate Boulevard Rockville MD 20850
MAR 3 0 2006
Atrium Medical Corporation c/o Ms. Karen Hall Director, RA/QA 5 Wentworth Drive Hudson, NH 03051
Re: K060124
Trade Name: Atrium Flixene Graft ( 3mm to 30mm ) Regulation Number: 21 CFR 870.3450 Regulation Name: Vascular Graft Prosthesis Regulatory Class: Class II Product Code: DSY Dated: February 27, 2006 Received: February 28, 2006
Dear Ms. Hall:
We have reviewed your Section 510(k) premarket notification of intent to market the device referenced above and have determined the device is substantially equivalent (for the indications for use stated in the enclosure) to legally marketed predicate devices marketed in interstate commerce prior to May 28, 1976, the enactment date of the Medical Device Amendments, or to devices that have been reclassified in accordance with the provisions of the Federal Food, Drug, and Cosmetic Act (Act) that do not require approval of a premarket approval application (PMA). You may, therefore, market the device, subject to the general controls provisions of the Act. The general controls provisions of the Act include requirements for annual registration, listing of devices, good manufacturing practice, labeling, and prohibitions against misbranding and adulteration.
If your device is classified (see above) into either class II (Special Controls) or class III (PMA), it may be subject to such additional controls. Existing major regulations affecting your device can be found in the Code of Federal Regulations, Title 21, Parts 800 to 898. In addition, FDA may publish further announcements concerning your device in the Federal Register.
{1}------------------------------------------------
Page 2 - Ms. Karen Hall
Please be advised that FDA's issuance of a substantial equivalence determination does not mean r lease be actived and thermination that your device complies with other requirements of the Act or any Federal statutes and regulations administered by other Federal agencies. You must or uny I vith all the Act's requirements, including, but not limited to: registration and listing (21 CFR Part 807); labeling (21 CFR Part 801); good manufacturing practice requirements as set forth in the quality systems (QS) regulation (21 CFR Part 820); and if applicable, the electronic product radiation control provisions (Sections 531-542 of the Act); 21 CFR 1000-1050. This letter will allow you to begin marketing your device as described in your Section 510(k) Premarket notification. The FDA finding of substantial equivalence of your device to a legally premaince nevice results in a classification for your device and thus, permits your device to proceed to the market.
If you desire specific advice for your device on our labeling regulation (21 CFR Part 801), please contact the Office of Compliance at (240) 276-0120. Also, please note the regulation entitled, "Misbranding by reference to premarket notification" (21CFR Part 807.97). You may obtain other general information on your responsibilities under the Act from the Division of Small Manufacturers, International and Consumer Assistance at its toll-free number (800) 638-2041 or (301) 443-6597 or at its Internet address http://www.fda.gov/cdrh/industry/support/index.html.
Sincerely yours,
Bhimmon for
Bram D. Zuckerman, M.D. Director Division of Cardiovascular Devices Office of Device Evaluation Center for Devices and Radiological Health
Enclosure
{2}------------------------------------------------
Indications For Use
510(k) Number (if known): K060124
Device Name:
Indications For Use:
The Atrium Flixene Graft is intended for use in arterial vascular reconstruction, segmental bypass, and for arteriovenous vascular access. Insufficient data is available at this time to support Atrium Flixene Graft use in aortocoronary bypass applications or for use as a patch.
Prescription Use _X
AND/OR
Over-The-Counter Use
(Part 21 CFR 801 Subpart D)
(21 CFR 807 Subpart C)
(PLEASE DO NOT WRITE BELOW THIS LINE-CONTINUE ON ANOTHER PAGE IF NEEDED)
Concurrence of CDRH, Office of Device Evaluation (ODE)
Bhemnuna
(Division Sign-Off)
Division of Cardiovascular Devices
510(k) Number K060124
Page 1 of __ 1_
Atrium Medical Corporation
CONFIDENTIAL
§ 870.3450 Vascular graft prosthesis.
(a)
Identification. A vascular graft prosthesis is an implanted device intended to repair, replace, or bypass sections of native or artificial vessels, excluding coronary or cerebral vasculature, and to provide vascular access. It is commonly constructed of materials such as polyethylene terephthalate and polytetrafluoroethylene, and it may be coated with a biological coating, such as albumin or collagen, or a synthetic coating, such as silicone. The graft structure itself is not made of materials of animal origin, including human umbilical cords.(b)
Classification. Class II (special controls). The special control for this device is the FDA guidance document entitled “Guidance Document for Vascular Prostheses 510(k) Submissions.”